Water Temperature Gauge Not Working
Thread Starter
Junior Member
Joined: Dec 2009
Posts: 23
Likes: 0
From: Kelowna, BC
Car: 1974 Camaro Z28 Type LT
Engine: 350 sbc
Transmission: Borg Warner T5
Water Temperature Gauge Not Working
Last night I went and changed the O2 sensor on my car. Now the temperature gauge isn't working. Is there any wires around the O2 sensor that I might have bumped that could cause this?
1989 Pontiac Firebird w/ 305 TBI
1989 Pontiac Firebird w/ 305 TBI
Junior Member
Joined: Sep 2010
Posts: 30
Likes: 0
From: enterprise al
Car: 88 camaro
Engine: 5.7
Re: Water Temperature Gauge Not Working
if you disconnect the connector for the temp sensor there should be 2 pin slots, if you short them out (useing a paper clip, piece of wire, etc) and turn your ignition to the accessory spot, your gauge should peg out to the max. if it doesn't do that, then that means that you have bad wiring or gauge, if it does, you have a bad temp sensor.
Moderator
Joined: Jan 2000
Posts: 20,981
Likes: 11
From: Mercedes Norte, Heredia, Costa Rica
Car: 1984 Z28 Hardtop
Engine: 383 Carb
Transmission: 4L60
Axle/Gears: 3.54 Dana 44
Re: Water Temperature Gauge Not Working
The temperature gauge sender is in the driver side head between #1 and #3 cylinders. It's possible you could have disturbed the wiring.
Thread Starter
Junior Member
Joined: Dec 2009
Posts: 23
Likes: 0
From: Kelowna, BC
Car: 1974 Camaro Z28 Type LT
Engine: 350 sbc
Transmission: Borg Warner T5
Supreme Member
iTrader: (6)
Joined: Aug 2009
Posts: 3,670
Likes: 3
From: Elwood, IN
Car: 1986 camaro Sports Coupe
Engine: L31 350
Transmission: 89 700R4
Axle/Gears: 3.42 gov lock
Re: Water Temperature Gauge Not Working
do you have a picture of that wire? my gauge pegs when cranking but it wont ever move? is that a sign of a bad sensor?
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
