May I use my stock PVC hoses on tall style valve covers?
May I use my stock PVC hoses on tall style valve covers?
I was thinking the tall valve covers would be too high for the stock PVC pieces to snap into. How hard will it be to get these to mount securely into the taller covers?
I have some pics below. One shows the valve covers I'm thinking of buying because I need a taller valve cover for the roller rockers I'm buying.
The other picture is just of my current valve cover with the PVC valve hooked on it. It is of the driver side valve cover.
Uploaded with ImageShack.us
Uploaded with ImageShack.us
I have some pics below. One shows the valve covers I'm thinking of buying because I need a taller valve cover for the roller rockers I'm buying.
The other picture is just of my current valve cover with the PVC valve hooked on it. It is of the driver side valve cover.
Uploaded with ImageShack.us
Uploaded with ImageShack.us
Supreme Member
Joined: Feb 2010
Posts: 1,446
Likes: 2
From: Orlando
Car: 1991 Camaro Z28
Engine: 357, Canfield heads, solid roller,
Transmission: Upgraded 03 Cobra T56
Axle/Gears: 9" 3.50 gears and Detroit Locker
Re: May I use my stock PVC hoses on tall style valve covers?
Should fit fine, but if not its just 3/8" rubber hose. You can get it at Auto Zone for about a dollar a foot.
Supreme Member
iTrader: (4)
Joined: Mar 2009
Posts: 3,079
Likes: 4
From: Pepperell, MA
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: May I use my stock PVC hoses on tall style valve covers?
you may need to grab a new rubber grommet for the pcv to sit in on the valve cover. your local auto part store should have a decent variety to look through. nothing majorly difficult
Re: May I use my stock PVC hoses on tall style valve covers?
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 25, 2015 11:49 PM
Street Lethal
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 12, 2015 11:33 AM
