Flat-top 350 bottom end w/ 416's. Plug gap????
Thread Starter
Junior Member
Joined: Feb 2008
Posts: 53
Likes: 0
From: San Diego
Car: TA
Engine: 5.7 CCC
Transmission: Manual
Axle/Gears: 3.70
Flat-top 350 bottom end w/ 416's. Plug gap????
As stated in the title, roller 350 w/ flat-top pistons and 416 heads. Anyone have an opinion as to what plug gap to run? .045 or .035? CCC carb (not that it should matter)...
Thanks
Randy
Thanks
Randy
Joined: Sep 2005
Posts: 27,936
Likes: 2,454
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Flat-top 350 bottom end w/ 416's. Plug gap????
Yes there should be some plug gap.
.040" is fine. So is .035" or .045". Doesn't really matter, you won't be able to tell any difference at all.
Of all the things that are important about fine-tuning, that's pretty low on the list.
.040" is fine. So is .035" or .045". Doesn't really matter, you won't be able to tell any difference at all.
Of all the things that are important about fine-tuning, that's pretty low on the list.
Thread
Thread Starter
Forum
Replies
Last Post
