cts proper install question
Thread Starter
Member
Joined: Dec 2011
Posts: 208
Likes: 5
From: south florida
Car: 88 firebird convertible
Engine: 305 tbi v8
cts proper install question
hey guys, ive noticed that my cts on my 305tbi isnt completely screwed in.. and when i attempt to it feels as if its gone far enough without snapping. my question is, does the sensor have to touch the body of the manifold with the base of the sensor, or seeing a few threads be ok?? i ask cuz ive never noticed before, and my mechanics' believe that my car is acting up because of the CTS. ive changed that part about 4 times in 8 months...
so does it have to be completely screwed in??? or a couple threads out ok??
so does it have to be completely screwed in??? or a couple threads out ok??
Supreme Member
iTrader: (3)
Joined: Nov 2001
Posts: 2,428
Likes: 2
From: Fairview Heights Illinois
Car: 1986 Irocz
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3.25:1
Re: cts proper install question
It only has to seal, but two threads are not enough even for that.
Thread
Thread Starter
Forum
Replies
Last Post
