Will it fit (LT1 gas tank)
#1
Junior Member
Thread Starter
Join Date: Jul 2004
Location: St Catharines
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 IROC
Engine: LS1
Transmission: T-56
Axle/Gears: 3:42, 10 Bolt LT1
Will it fit (LT1 gas tank)
I am in the process of swapping over an LT1/T56 from a 97 donor car into a TBI 89 Camaro. I pulled both gas tanks and I found the fourth gen unit is in much better condition, and it appears the third gen one was leaking from the sending unit. Originally I was going to sell the LT1 fuel tank and put in a AC Delco EP381 unit into the third gen tank.
Based on these pictures, the dirty tank is the third gen, is there any reason why I wouldn't be able to use the fourth gen unit? Would I be able to use my new pump if I did run it? Thanks.
Based on these pictures, the dirty tank is the third gen, is there any reason why I wouldn't be able to use the fourth gen unit? Would I be able to use my new pump if I did run it? Thanks.
#2
Member
iTrader: (1)
Join Date: Sep 2011
Location: Birmingham, Alabama!!!
Posts: 316
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Iroc-Z
Engine: 350 TPI; Stock internals
Transmission: 700r4; TCI-CPVB; BW Hi-Frition
Axle/Gears: 4th gen 7.5 w/ 3:42 gear
Re: Will it fit (LT1 gas tank)
Whip your measuring stick out and get the height, width and any other 'contact' points... if they are roughly the same, then i'd say yes it would work
#3
Junior Member
Join Date: Feb 2013
Location: Vancouver BC Canada
Posts: 28
Received 0 Likes
on
0 Posts
Car: 91 z28 convertible
Engine: 350lt1
Transmission: T56
Axle/Gears: 3.73
Thread
Thread Starter
Forum
Replies
Last Post
AkDrifted
Engine/Drivetrain/Suspension Parts for Sale
6
08-17-2015 07:45 PM