I am working on a 90 Camaro 350 TPI. I just replaced the injectors and think I may have crossed a couple of vacuum lines. It is idling almost like it has a miss. Can anyone tell me where the vacuum hose from the throttle body goes to? Also, where does the line from the vacuum canister(behind drivers side headlight) go to? Also, the 2 lines that come off the EGR solenoid? I have following the vacuum diagram as best I can but want to double check. Thanks in advance.

 

Bottom port ( vac ) on TB goes to canister purge solenoid ( then to canister )
Top port is PCV supply air to pass side rocker cover

One vac line goes to the EGR valve under plenum;
the other is the supply vac

 

What about the vacuum line underneath the throttle body? Also what lines run to/from the check valve by the ignition coil?

 

egr soilonoid... one to the egr valve the other to underneath trottle body

 

Got those connected correctly....where does the vacuum port on the MAP sensor go...to the fuel pressure regulator?? One more...where does the 2 lines from the check valve next to the MAP sensor go? Thanks