car wont 'pull' or shift after 4500 rpm..???
Thread Starter
Member
Joined: Apr 2008
Posts: 322
Likes: 1
From: Mechanicsville VA
Car: 1991 Z-28
Engine: 383 TPI
Transmission: 700R4
Axle/Gears: 2.73
car wont 'pull' or shift after 4500 rpm..???
heres the deal....91 z28. 305 tpi. stock except i did replace all the injectors (ford svo injectors) about 15000 miles ago.
from a stop..wide open throttle... pulls good then gets to about 4500 rpm and just flat stops accelerating. rpms 'hang' at 4500, car doesn't shift...it does this for about 2 seconds and then will shift and start pulling again.
new plugs, wires, cap, rotor, fuel filter, etc... i thought i had a clogged cat converter (was original one) so i replaced it, same thing, no change.
i checked fuel pressure thinking maybe i had a bad fuel pump or regulator...pressure looked good.
sometimes it does not exhibit this problem at all...winds up to about 5000, shifts and keeps pulling. but most of the time it gets to 4500 or so and just stops.....any thoughts? (i did adjust the TV cable as well thinking it was a trans issue at first)
from a stop..wide open throttle... pulls good then gets to about 4500 rpm and just flat stops accelerating. rpms 'hang' at 4500, car doesn't shift...it does this for about 2 seconds and then will shift and start pulling again.
new plugs, wires, cap, rotor, fuel filter, etc... i thought i had a clogged cat converter (was original one) so i replaced it, same thing, no change.
i checked fuel pressure thinking maybe i had a bad fuel pump or regulator...pressure looked good.
sometimes it does not exhibit this problem at all...winds up to about 5000, shifts and keeps pulling. but most of the time it gets to 4500 or so and just stops.....any thoughts? (i did adjust the TV cable as well thinking it was a trans issue at first)
Thread
Thread Starter
Forum
Replies
Last Post
