Not sure where to post this.


I am looking at these two,

http://www.sears.com/shc/s/p_10153_12605_00916477000P

http://www.tractorsupply.com/en/stor...pressor-80-gal



i''ll Prob pick this one up this week, Now I need Regulator help, I can' seem to find a decent one, I would like it to adjust to the full 175 PSI this Compressor will put out.

http://www.tractorsupply.com/en/stor...pressor-80-gal

 

I would go with IR brand also.
Check out paint supply stores or paint gun manufacturers, they have regulators, seperators and all the cool toys for that. Buy a auto condensation drain also, worth its weight in gold.
Get all your accessories for as big of a line as you can. It makes the tools work easier. Esp if you have a 1/2 Snap On impact gun. Those like volume. I have a matco now and it works great on a lot less volume of air but I still have big lines.

 

I may put a t in line, so I'll have the reg on one out put and a full power port. I use 1/4 NPT Fittings, but the threads off of the compressor ball valve is 3/4 Thread I think.