Fair price for this machining???
Thread Starter
Supreme Member
iTrader: (2)
Joined: May 2007
Posts: 2,574
Likes: 0
From: right behind you
Car: '85 maro
Engine: In the works...
Transmission: TH700 R4
Axle/Gears: 3.73 posi
Fair price for this machining???
What would a fair price be for offset grinding a crank and machining the integral reluctor to match another crank? It's basically just turning the reluctor on a lathe and milling tangs into the reluctor. Already had the job done I just want to be sure $350 sounds reasonable.
Thread
Thread Starter
Forum
Replies
Last Post