So, my fuel pump recently went out in my 91 z28, and I have decided to do the access panel in the trunk (Please don't bore me with opinions, I have done access panels in many cars. I know the pros and cons, and I know how to do cut it and how gentle to be without accidentally hitting fuel lines.) What I need, however, is to know where I should be cutting into the trunk. There was a thread a while back that had the diagram and specifics as to where the lines are, where the panel should be cut, etc. But I can't seem to find it.

If any of you guys know where this thread is or have done your own access panels and can post the dimensions of where this should be cut, PLEASE let me know. It would be VERY much appreciated.

Thank you,
Tonya.

 

Check out the video posted in this thread - it may help you out:

https://www.thirdgen.org/forums/elec...eads-full.html

 

https://www.thirdgen.org/forums/post...137-post2.html

https://www.thirdgen.org/forums/post...40-post14.html

 

This is a little less specific than the thread, but this is SO incredibly helpful. THANK YOU so much.

 

And this is EXACTLY the posts I was looking for.