Hey guys,

355's goin off to the machine shop, things are rolling now. I'm wondering who's ran a pretty wild TPI setup on a stock chip? I dont want to lean out, or run to advance and ruin this freshly built engine, but I can't customize the prom yet for a few weeks/months. Here's the more important parts of the set up.

Iron Eagle 180cc's ported/polished
9.7:1 compression
212 218 @ .05 520 lift 112 lsa
Stock 22lb/hr injectors
semi-siamesed ported intake/ fully siamesed SLP runners
stock 305 (48mm?) TB
ported plenum (laff)
3.73's (less engine load?)
shift kit, dual exhaust

So who's experienced a similar set up on a stock chip? anybody pulled data and found any lean/knock conditions?
thanks!