Please close thread
Joined: Jun 2003
Posts: 5,028
Likes: 78
From: Desert
Car: 1991 Z28 Vert
Engine: 383 single plane efi
Transmission: T-56
Axle/Gears: 8.8 with 3.73s
Re: fuel sender unit- insulation coming off of wire
Solder in a new wire section. Don't use electrical tape for sure. I'm not even sure if heat shrink would hold up gas though. I would repost this in electronics.
Thread Starter
Member
Joined: Feb 2014
Posts: 162
Likes: 2
Car: 1983 Z-28
Engine: 305 LG4
Transmission: 5-speed
Re: fuel sender unit- insulation coming off of wire
Thanks Tibo. I will try to repost in electronics. My only worry about soldering a different wire in is, will that wire's insulation hold up to the Ethanol exposure?
Thread
Thread Starter
Forum
Replies
Last Post
sheltonw3
Tech / General Engine
4
Dec 7, 2016 01:17 PM
padak
Engine/Drivetrain/Suspension Parts for Sale
23
Oct 12, 2016 07:58 AM
