CSI screw size?
Thread Starter
Supreme Member
iTrader: (8)
Joined: Aug 2003
Posts: 7,240
Likes: 6
From: LeRoy, NY
Car: 2003 Hyundai Tiburon GT
Engine: 2.7L V6
Transmission: 6-speed
Axle/Gears: 4.41
CSI screw size?
I'm looking at getting a FOURTH cold start injector... from my local junkyard. The donor is relatively clean except that it's missing stuff from the B-pillars back... It's a TPI, I believe it's a 305 by the VIN but could have been swapped I suppose.
Question: What size Torx is used on the retaining screw? It's not a 10mm like I was expecting... looks like a T40?
I'm hoping this one works at least a little. I have 3 now that don't and I'm tired of having to open my hood just to start the car when it's cold.
Question: What size Torx is used on the retaining screw? It's not a 10mm like I was expecting... looks like a T40?
I'm hoping this one works at least a little. I have 3 now that don't and I'm tired of having to open my hood just to start the car when it's cold.
Thread
Thread Starter
Forum
Replies
Last Post