Sbc combo input
10-17-2018, 10:14 PM
#1
Junior Member
Thread Starter
Join Date: Oct 2018
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Sbc combo input
What do you guys think about this setup. 350 punched 40 with a 3.75 stroke (385) sportsman 2 heads 200cc runners 72cc chambers with a 3 angle valve job. Competition products single plane intake(painted black of that helps the hp #s) 👏 Intake starts at 3k to 7k..125 dome kb pistons on 5.7 rods. Elgin 1090p solid flat tappet. Specs are Cam Lift=.358" Int./.371" Exh. - Valve Lift=.537" Int./.557" Exhaust - Duration=287°s Int./295°s Exh. - Duration@.050" = 256°s Int./ 264°s Exh. - 105° Lobe Center. Built turbo 350 claimed to handle 600ish hp. Haven’t picked a stall but leaning towards a 3500. 4:11 gear. Motor is going in a full interior G body. Any input is greatly appreciated
10-17-2018, 10:32 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,110
Received 1,686 Likes
on
1,281 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Sbc combo input
I would not use S2 heads on anything I built today that I expected to be competitive.They're not "bad" or anything like that, only, seriously obsolete.
Ever owned a solid lifter cam before?
You're aware this is a site for 82-92 F body; while we appreciate being thought of as a source of knowledge especially about the old small-block Chevy motor, we refer people with other vehicles, to sites specializing in them.
Ever owned a solid lifter cam before?
You're aware this is a site for 82-92 F body; while we appreciate being thought of as a source of knowledge especially about the old small-block Chevy motor, we refer people with other vehicles, to sites specializing in them.
Thread
Thread Starter
Forum
Replies
Last Post
BlueZee28
Suspension and Chassis
20
12-31-2013 05:32 AM
SR71BLKBRD
Tech / General Engine
6
08-01-2012 05:31 PM
Josh91Bird
Tech / General Engine
6
10-09-2001 11:53 PM