Needing ROD length for the "baby" LT1??
Thread Starter
Junior Member
Joined: Nov 2018
Posts: 8
Likes: 0
Needing ROD length for the "baby" LT1??
Good morning.
I'm getting conflicting info on the length of the Baby LT1 rods.
It's the 4.3 NOT the 5.7 motor that came in the Caprice.
My caliper doesn't go that far, and it's kinda hard to get a measurement with the piston on.
Thanks for your help.
E
I'm getting conflicting info on the length of the Baby LT1 rods.
It's the 4.3 NOT the 5.7 motor that came in the Caprice.
My caliper doesn't go that far, and it's kinda hard to get a measurement with the piston on.
Thanks for your help.
E
Joined: Jan 2005
Posts: 10,404
Likes: 492
From: Hurst, Texas
Car: 1983 G20 Chevy
Engine: 305 TPI
Transmission: 4L60
Axle/Gears: 14 bolt with 3.07 gears
Re: Needing ROD length for the "baby" LT1??
5.94" center of the connecting rod bore to the center of the piston pin bore.
Thread
Thread Starter
Forum
Replies
Last Post
Artic-Trans am
Tech / General Engine
13
Dec 3, 2015 03:46 AM