Mounting the org exhaust manifold
Thread Starter
Junior Member
Joined: May 2012
Posts: 10
Likes: 0
From: Fagersta Vastmanland
Car: Camaro iroc z conv
Engine: 350 tpi
Transmission: th700r4
Axle/Gears: gen 4 rear axel 3.27 ratio
Mounting the org exhaust manifold
My headers cracked so Im going back to the cast iron stock ones on my car. But I dont remember what hardware I need, and therefore I need help.
One part is WALKER31533 but is there another gasket that is requierd when mounting it and some springs? and also what threads are the bolts that go down into the ypipe? I dont have the nuts that goes with them
One part is WALKER31533 but is there another gasket that is requierd when mounting it and some springs? and also what threads are the bolts that go down into the ypipe? I dont have the nuts that goes with them
Thread
Thread Starter
Forum
Replies
Last Post