NEED HELP FAST PLEASE!!!! No Juice to starter
Thread Starter
Member
Joined: Dec 2000
Posts: 335
Likes: 0
From: Glen Burnie, MD USA
Car: 1989 IROC
Engine: 350
Transmission: T56
NEED HELP FAST PLEASE!!!! No Juice to starter
My car does nothing when you turn the key. Everything else works, including the fuel pump. I have juice to the alternator and the car turns over when i run a hot wire across the solenoid. So, somewhere between the ignition and the starter solenid I am losing juice---any ideas fellas? My car is stuck in school parking lot.
Tim
Tim
Ring,
There is a starter enable relay in the left kick panel area of some cars. I'm not sure what years. if your VATS is preventing you from starting, the light should be flashing continuously. Turn the key to "RUN" without cranking it and observe teh light. What's happening?
GMTech has a great overview of the system on his site: http://www.sethirdgen.org/vats.htm
There is a starter enable relay in the left kick panel area of some cars. I'm not sure what years. if your VATS is preventing you from starting, the light should be flashing continuously. Turn the key to "RUN" without cranking it and observe teh light. What's happening?
GMTech has a great overview of the system on his site: http://www.sethirdgen.org/vats.htm
Last edited by Vader; Mar 14, 2002 at 08:58 PM.
Supreme Member
Joined: Feb 2002
Posts: 2,308
Likes: 0
From: Avondale, AZ
Car: currently thirdgenless!!!
Vader,
Is the starter enable relay and the starter relay the same thing.
Could the starter relay be the cause of my car clicking a few times before it starts???
Bill
Is the starter enable relay and the starter relay the same thing.
Could the starter relay be the cause of my car clicking a few times before it starts???
Bill
Thread Starter
Member
Joined: Dec 2000
Posts: 335
Likes: 0
From: Glen Burnie, MD USA
Car: 1989 IROC
Engine: 350
Transmission: T56
Vader,
I do not have a light anymore--I have custom gauges installed. I took out the lock cylinder and it appears that one of the wires was broken, unless I broke it taking the cylinder out. Anyway, using the tech article to bypass the VATS, can i just put the resistor in bewteen the two wires that go to the lock cylinder? In other words, can i take the two wires off of the cylinder and then just solder the resistor in between the two wires, connecting them through the resistor and therefore bypassing the lock cylinder all together?
Thanks
Tim
I do not have a light anymore--I have custom gauges installed. I took out the lock cylinder and it appears that one of the wires was broken, unless I broke it taking the cylinder out. Anyway, using the tech article to bypass the VATS, can i just put the resistor in bewteen the two wires that go to the lock cylinder? In other words, can i take the two wires off of the cylinder and then just solder the resistor in between the two wires, connecting them through the resistor and therefore bypassing the lock cylinder all together?
Thanks
Tim
Thread
Thread Starter
Forum
Replies
Last Post
Gunner242
Electronics
7
Dec 25, 2015 04:49 PM




Could it be the damn VATS or what? 



