I just ordered some center bolt wires looms and am curious about custom lengthening my wires cause I really want that clean tight look under the hood. Would I be able to use my current MSD's and just get a crimping tool, or will I have to get new boots and wires along with a tool. Anyone that has done this please throw in your .02's on time, tools and parts I'll need.

Thanks,
Tom

 

Just get a crimping tool. Thats what i did when I installed my headers and I didn't wana buy another new set of taylor wires so I just switched a few boots around, custom the length and was done with it. All you need to do is use a screwdriver to push the metal part out of the boot and the rest you should be able to figger out yourself.