I have an 87 TA with the stupid square box MAF intake system, how can I get rid of that stupid box and not screw up the MAF sensor? I am thinking about a 52mm throttle body, ported plenum, ported runners, and a ported intake, but first I need to do something about that box and the intake into the throttle body, can anyone help me out?

 

Three words: cold air intake. Try slp, here is a link http://www.slponline.com/view_produc...RTNUMBER=21001 Lots of people make their own too. I'll probably make some sort of ram air setup when i switch to TPI, but i don't have the firebird intake. Just get a 350

------------------
91 metallic blue RS Flowmaster exhaust, Eibach Sportline Springs, Open element, 323 posi rear w/ 4 wheel discs. 350 comming soon.

 

Thanx for the advice, sorry about posting this in the wrong board, I wasn't paying attention. I'm leaning toward the cold air intake, but does anyone know how to make one yourself?

 

I replaced the crappy intake in my 87 GTA...go here for some HUGE pictures and instructions.

http://www.geocites.com/jonathan_badgett/

Email me if you have any questions.

------------------
~3.1EyeCandy~
"The Car that started my craze"

'92 Firebird 3.1 (A car sold)

My new baby: '87 flame red GTA 350 w'auto, ported and polished plenum, custom cold-air intake w/K&N, 180* thermostat, Hooker SuperComp Exhaust, Splitfire plugs, Hypertech Airfoil,
Carmine interior with pioneer all around
My Cars

jonathan_badgett@yahoo.com