Someone on this site had a link in their signature to a really good one,But i forgot who the person is and the name of the page.It had information on how to build a 245 h.p. "Iron Duke" 4 cylinder.Does anyone know about this page? I apologize to the moderators because i know this is off-topic,But i wasn't sure where else to post this.Thanks.

------------------
82 firebird with 305H.O.,Block bored .30 over,Keith black hyperutectic flat top pistons for 10 to 1 compression,Turned crank,Magnafluxed connecting rods,Melling H.V. oil pump,and double roller timeing chain,Ported and shaved heads w/3angle valve job,Z-28springs,Summit push rods and comp cams magnum roller rockers,Ported Edelbrock performer r.p.m.intake,Carter 625 afbcarb,Accell spark plugs,wires,and H.E.I.super coil,Heavy duty cap and rotor,Clevite performance cam with 450-460 inches of lift,Comp cams lifters,700r-4 tranny rebuilt with trans-go rebuild kit,corvette servo,New torQue converter,Flowtech headers,Flowmaster muffler,3.73limited slip rear end,Energy suspension bushings from front to rear,Energy suspension tranny mount,New center link,ball joints,trans-am steering box,ASP power pully,Boxed L.C.A.'s.

 

good forum to get info from is
www.fiero.nl

------------------
imports are cool - ricers suck
ICQ 4116192
AIM RXspeed87
Got rotary?
running a turbo motor with 12psi.
full dual 3 1/2" pipes comming off the turbo
FMIC,CAI, ram air, e-fan,
soon to have ported intake,TB, and motor
best time 12.5 on G-tech
prev best time 14.8

hoping for 11.x soon :-)
but I broke another driveshaft...

and still running full street trim :-)

 

Thanks for the help,rx7speed!

------------------
82 firebird with 305H.O.,Block bored .30 over,Keith black hyperutectic flat top pistons for 10 to 1 compression,Turned crank,Magnafluxed connecting rods,Melling H.V. oil pump,and double roller timeing chain,Ported and shaved heads w/3angle valve job,Z-28springs,Summit push rods and comp cams magnum roller rockers,Ported Edelbrock performer r.p.m.intake,Carter 625 afbcarb,Accell spark plugs,wires,and H.E.I.super coil,Heavy duty cap and rotor,Clevite performance cam with 450-460 inches of lift,Comp cams lifters,700r-4 tranny rebuilt with trans-go rebuild kit,corvette servo,New torQue converter,Flowtech headers,Flowmaster muffler,3.73limited slip rear end,Energy suspension bushings from front to rear,Energy suspension tranny mount,New center link,ball joints,trans-am steering box,ASP power pully,Boxed L.C.A.'s.

 

http://www.v8archie.com/ has some cool stuff

and i think

http://www.cliffordperformance.com/catalog.htm

actually has some 4-cyl stuff last i remember



------------------
88 Camaro (The mighty LO3 SC!)
305TBI/700R4/2.73/125,XXX miles
10" Open Element and Flowmaster 80 seires
Bosch Platinum plugs
Double silicone Accel wires


Next up: headers and gears