I was wondering:

1)..what equipment I need to burn my own chips (for TPI)?

2) How much would the starting cost be?

3) Can I burn the same chip many times or do I alwais have to start with a fresh one?

4) How much would "fresh" chips cost?

I want to be able to compare the cost of burning chips vs. buying an aftermarket ECM.

Thanks in advange,

Nonni

 

you are probably gonna get beaten over the head with this but all the info you want is right here:

https://www.thirdgen.org/newdesign/tech/promintro.shtml

 

Nonni :lala:

 

CAuse your from Iceland, Ill keep My Billy Club in check...

THIS TIME!

( Way cheaper than an aftermarket ECM )

 

I wish i never spen the money with any aftermarket chips :-( got an expensive desk toy now thouhg lol

its not that bad cost wise , eeprom last almost forever and u can tune anything u want any way u want

and once u play around u get faster and faster

i just got my setup working this week(diacom,pocketprogramme2,tunercat) and already on my third different burn with major changes in them all (redone according to diacom)
later
give it a shot u will be suprised

 

Whoa I was about to ask the same question. Thanks for saving me from a beating Nonni.