flow #'s ??
Thread Starter
Senior Member
Joined: Nov 2000
Posts: 762
Likes: 1
From: down by the river
flow #'s ??
does anyone have some approx flow #'s (.500" is fine) for STOCK L98 iron heads? How about fully ported iron L98 heads.
Also, I am installing a Crane Compucam 214/220 duration and can't decide between TFS G2 heads with ported base and plenum, or Vortec heads and Vortec base along with ported plenum.
Any flow #'s on these heads would be great. I think I will make more power with the Vortec set-up....agree?
Also, I am installing a Crane Compucam 214/220 duration and can't decide between TFS G2 heads with ported base and plenum, or Vortec heads and Vortec base along with ported plenum.
Any flow #'s on these heads would be great. I think I will make more power with the Vortec set-up....agree?
Member
Joined: Mar 2001
Posts: 376
Likes: 2
From: Cottonwood, AZ 86326
Here ya go.
https://www.thirdgen.org/techbb2/sho...ight=iron+head
https://www.thirdgen.org/techbb2/sho...n+head+project
Been workin' too darn hard to do part 4 yet, but the flow met or exceeded most aftermarket heads in the less than 200cc runner range.
https://www.thirdgen.org/techbb2/sho...ight=iron+head
https://www.thirdgen.org/techbb2/sho...n+head+project
Been workin' too darn hard to do part 4 yet, but the flow met or exceeded most aftermarket heads in the less than 200cc runner range.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM