removing TPI harness
Thread Starter
Member
Joined: Aug 2001
Posts: 483
Likes: 0
From: Dallas, Tx
Car: 88 Trans Am
Engine: lt1 intaked 355 makin 277 on 25 psi of fuel pressure and stock timing :)
Transmission: A4 stock... that moved a mobile dyno a foot shifting into 2nd :)
removing TPI harness
what all will i have to do to remove the computer, harness and what sensors will i need to take out as well? and is it easy?
Senior Member
iTrader: (1)
Joined: Jun 2001
Posts: 897
Likes: 0
From: Maryland
Car: 1993 Toyota Supra
Engine: Inline 6
Transmission: 6 Speed
Axle/Gears: 3.13
very easy, remove the block from the firewall, it is held in place with a screw. Use a 1/4" to get the screw out. The harness is also held in place right where the interior meets the fender area with like a U clip sorta thing. That clip needs to be pulled up but it is tricky to get the thing to release. Everything else is pretty much straight forward.
Supreme Member
Joined: Oct 2000
Posts: 1,052
Likes: 0
From: Lima, Ohio
As already stated, its pretty straight forward. Don't get in a rush and start pulling, its a pain getting the harness out of the fender opening, but work with it a little and it clears.
Brendan
Brendan
Thread
Thread Starter
Forum
Replies
Last Post
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM
