Third Generation F-Body Message Boards

TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

distrubutor question

Thread Tools
 
Search this Thread
 
Old Feb 10, 2003 | 05:04 PM
Share
  #1  
Nasty_Bird_'90's Avatar
Nasty_Bird_'90
Thread Starter
Senior Member
 
Joined: Jan 2002
Posts: 951
Likes: 0
From: Under the hood.
distrubutor question
My distributor won't seat all the way in the block. The little flange on the shaft wont sit flush with the intake manifold. Anyone know why? Thx.
Reply
0
Old Feb 10, 2003 | 05:10 PM
Share
  #2  
92 zzz28's Avatar
92 zzz28
Supreme Member
 
Joined: Nov 2001
Posts: 1,886
Likes: 0
From: Jacksonville, NC
Car: Guess
Engine: Crazy 8
Transmission: So close to being a manual I can taste it
It sounds like the oil pump drive shaft is not engaged into the bottom of the distributor.
Reply
0
Old Feb 10, 2003 | 09:17 PM
Share
  #3  
Nasty_Bird_'90's Avatar
Nasty_Bird_'90
Thread Starter
Senior Member
 
Joined: Jan 2002
Posts: 951
Likes: 0
From: Under the hood.
i got it fixed. you were close. The driveshaft wasn't engaged on the pump. thanx.
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Lets talk drag radials
fasteddi
Organized Drag Racing and Autocross
15
Sep 10, 2015 09:32 AM
PowerMax 2032 good DD cam?
masonta
Power Adders
0
Sep 1, 2015 06:40 PM
Ground and Power wiring HELP
Bubbajones_ya
Electronics
4
Aug 31, 2015 12:02 PM
Basic Tuning Questions
ezobens
DIY PROM
8
Aug 19, 2015 10:29 PM
Tick Master cylinder ?
redmaroz
LTX and LSX
7
Aug 16, 2015 11:40 PM
Back to Subforum
TPI
View Next Unread
boiling/bubbling noise in the tank.




Advanced Search

All times are GMT -5. The time now is 12:01 PM.