I was in the process of installing Accel Runners, but ran into some problems. I crossthreaded one of the runner to manifold bolts (please don't make fun of me). I know I could take it out and retap it, but now I have decided to buy a new Accel base. Anyhow to my question: should I get new injectors or just have mine cleaned and tested? I am planning on adding a little nitrous to the setup soon, so will the stock 22's be enough??? I found new 24# Accels for $215, so that seems like a good deal, but are they worth the prom burning I will have to do to get them to run right??? I know this has been discussed before but I could not find exactly what I needed by searching.

Any help would be appreciated...

Thanks,
Jonathan

 

depends on the future mods. If you are going to build the motor up, then Id say yes get the 24# injectors. As far as the stock injectors holding up to the N20 system, I think alot of guys on here are running it on a stock system.

Like I said, It depends on what your future plans are.