TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Closed Loop question

Thread Tools
 
Search this Thread
 
Old 03-04-2004, 08:22 AM
  #1  
Supreme Member

Thread Starter
 
pwdbychevy's Avatar
 
Join Date: Aug 2001
Location: Wesley Chapel, Florida
Posts: 1,337
Received 26 Likes on 13 Posts
Car: 1991 Camaro Z28
Engine: Dart SHP 406ci T88 turbo
Transmission: T56
Axle/Gears: QP 35 spline Ford 9" 3.50 gears
Closed Loop question

At what point does the system go into closed loop? Reason I ask is because my system is not going into closed loop. The engine runs for about 5 minutes and stays in open loop. Normally when in closed loop, the A/F gauge jumps back and forth from rich to lean but ever since my TBI to TPI swap the gauge reads 14.7/1. Does the coolant temperature have to reach a certain point before closed loop operation? Thanks.
Old 03-05-2004, 10:58 PM
  #2  
Senior Member
 
DANIELEK's Avatar
 
Join Date: Dec 2000
Location: Alberta
Posts: 550
Likes: 0
Received 0 Likes on 0 Posts
Car: Red Rooster
Engine: 305 TPI
Transmission: M5
There are many variables in the chip that allow your car to enter closed loop. In my chip I have to wait 300s, coolant temp has to reach 75 degrees and the oxygen sensor has to heat up to a certain temp. When all of these conditions are met your car will enter closed loop.

If you have headers and have moved your 02 down the pipe it will take longer for it to warm up and also it will take a long time when your car is idling..

If you need more info just visit the DIY Prom board..
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bamaboy0323
Tech / General Engine
25
09-03-2015 06:07 AM
CORV3TT3
DIY PROM
6
08-23-2015 11:26 AM
beast94
DIY PROM
4
08-20-2015 06:44 AM
redmaroz
LTX and LSX
7
08-16-2015 11:40 PM
IROCThe5.7L
DIY PROM
1
08-10-2015 11:24 AM



Quick Reply: Closed Loop question



All times are GMT -5. The time now is 10:56 AM.