hi, im new to the board, and joined to gain some knowledge on the L98. i own an 87 S10 blazer that currently sports an 89 4.3L V6 that i replaced the 2.8L with. i plan to swap in a L98 V8 this winter. im not looking for swap help, but more so help with the TPI.

i baught a "complete" TPI setup off of ebay reciently. its an 87 intake/plenum/runners, a 90 730 ECM, and a modified stand-alone harness. the problem is that the intake was bare, no brackets for coil, EGR solinoid, throttle cable, basically just fuel rails.

i was wondering if anyone could help me with part numbers. i tryed a search, but came up with few results. i was also hoping for some detaled pics of the intake to show mounting locations and wire routing. i've baught books but there not much help. thanks for any info that can be provided, Jim.

 

Hope the following will help you some, Jim.

 

2

 

3

 

thanks 92. i don't think it gets much more detailed than that. im sure that will help a ton. do you know if i can reuse some of the sonsors that are on my TBI? i know the knock is engine specific, but how about MAP, TPS, IAC, ect.

 

Anychance of some pics for a 85 or 86-89 Tpi System?

 

Hope this is what you're looking for.

Good luck.

 

Thanks