Well i am in need of the bottom intake so i thought i will get a modded one.

Mods i have done are, 3" headers and 3" hooker cat back.

Hope someone answers by tomorrow cause i need to place an order, so far i think EDL-3890 at summitracing.

Also, what hp gains can i expect?

thanks,

Sam

 

I ended up placing an order today What do you think of the intake I mentioned in the first post?

I chose that to stay on the emissions legal side.

What HP can i expect and most importantly will i feel it in my pants and get a smile ?

 

I run that intake on my TPI system. I had it extrude honed and I think it is a fine intake. However to get the most out of it you also need to get a good set of runners and port your plenum.

It is just one part of the intake system upgrade. The biggest single improvement will be a total upgrade of your exhaust system if you have not done so already. This would be from headers to a good cat-back system.

Be sure to port match everything. Allen

 

Oh, it comes with the runner. it ran at $690 I thought of porting the plenum and have that ready by the time the stuff get here