TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Bogging problems

Old Jul 9, 2005 | 03:33 AM
  #1  
RSblkcam's Avatar
Thread Starter
Member
 
Joined: Jul 2002
Posts: 132
Likes: 0
From: clarksville, tn
Car: 1991 Formula
Engine: 350 HSR
Transmission: TH-700R4
Axle/Gears: 10 bolt 3.73
Bogging problems

I am noticing (as well as some of my friends at the track) that my car is just stumbling off of the line and bogging pretty bad. I know my car is running really rich (almost to the point that it will burn your eyes if sat running long enough) and that my timing may be off since the HSR swap. The car feels pretty weak during the early part of acceleration (3000 and below), and then picks up in the higher RPMs. It is just odd that the car is running slower with HSR and full exhaust than it did when the car was stock. Any thoughts to my bogging issues? Also, this is being done on a stock chip.
Reply
Old Jul 9, 2005 | 08:57 AM
  #2  
91RS5speed's Avatar
Member
 
Joined: Sep 2002
Posts: 330
Likes: 1
From: Duluth, Ga
Car: 91 RS
Engine: 305 TPI
Transmission: T56
Axle/Gears: Auburn Pro / 3.42
Your proboly running to much fuel pressure or timing. try backing them off just alittle.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
14
Apr 28, 2019 07:45 AM
middian
Electronics
6
Sep 5, 2015 01:42 AM
andy74
Electronics
2
Sep 3, 2015 08:41 AM
GeneralIesrussi
Tech / General Engine
0
Sep 3, 2015 03:23 AM
greenyone
TPI
3
Sep 2, 2015 03:39 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 05:58 PM.