That ignition timing wire
Thread Starter
Joined: May 2005
Posts: 856
Likes: 10
From: West Palm Beach, FL
Car: 1991 Z28
Engine: SBC
Transmission: 700R4
Axle/Gears: 2.73
That ignition timing wire
Ok there are two wires and I cant figure out which is the ignition timing wire...1 is near the blower motor, and ac unit. Its a small wire thats tan. Then there a small wire back by the distributor, near the brake booster. 1 wire on this connection leads to my distributor
Joined: Aug 2005
Posts: 1,366
Likes: 1
From: louisville, ky
Axle/Gears: '01 3.42 10 bolt
the small tan wire by the blower motor is the wire you disconnect to set initial timing. if you did not disconnect this wire while setting the base timing, then your timing will be wrong.
Last edited by 87zjeff; Aug 29, 2005 at 01:10 AM.
Supreme Member
iTrader: (2)
Joined: Jul 2003
Posts: 3,205
Likes: 0
From: Dallas, TX area
Car: 91 Formula WS6 (Black, T-Tops)
Engine: 383 MiniRam (529 HP, 519 TQ - DD2K)
Transmission: Built '97 T56, Pro 5.0, CF-DF
Axle/Gears: 4.11 posi Ford 9"
Absolutely correct. Here's pic showing it courtesy of Vader, I believe.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
