**searched** how to modify stock valve covers to fit roller rockers...
Thread Starter
Member
Joined: Oct 2005
Posts: 126
Likes: 0
From: Lost Wages, NV
Car: 1988 IROC
Engine: 305 TPI
Transmission: 5 speed
Axle/Gears: 3.08 Posi 10 Bolt w/ aluminum drums
**searched** how to modify stock valve covers to fit roller rockers...
I have just installed a set of Comp Pro Mag 1.6 roller rockers with posi-locks.
they are comp part # 1318-16
what can I do to get my stock valve covers to fit??
if they wont, what are my options for replacement valve covers???
I thought about buying adapters and running perimeter bolt valve covers, but I'm not even sure that the adapters would fit between the rockers...
they are comp part # 1318-16
what can I do to get my stock valve covers to fit??
if they wont, what are my options for replacement valve covers???
I thought about buying adapters and running perimeter bolt valve covers, but I'm not even sure that the adapters would fit between the rockers...
Member
iTrader: (1)
Joined: Jun 2004
Posts: 348
Likes: 0
Car: 1987 Pontiac Trans Am GTA
Engine: 355 Stealth Ram
Transmission: 700R4 w/ 2600 stall
Axle/Gears: 9-bolt 3.27
Theres no need to do that all you have to do is cut the webbing that goes from the valve cover to the piece that the bolt goes through and they will fit trust me i have those same rocker arms and my fit just cut out about an inch off the bottom they will slide right on hope it helps Later Daniel
Joined: Mar 2000
Posts: 5,703
Likes: 132
From: Orange, CA
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
I didn't even cut mine, just bent the lip at the bottom straight and squeeze the baffle a little.
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 25, 2015 11:49 PM
Street Lethal
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 12, 2015 11:33 AM
