Does Hot Cam require ECM Changes
Thread Starter
Junior Member
Joined: May 2007
Posts: 16
Likes: 0
Does Hot Cam require ECM Changes
I got my engine started. It has a Comp Cam (very radical) I have to open the throttle on the TPI throttle body for it to start, but when I do it will run. My question is do I need to make ecm changes, or are there any other changes I should make to better tune my engine for it's mods? It is a 350 bored .060
12 to1 compression pistons. I am running an 86 TPI unit with MAF. It seems that the engine is needing to idle much faster than stock idle speed. Thanks for help guys
12 to1 compression pistons. I am running an 86 TPI unit with MAF. It seems that the engine is needing to idle much faster than stock idle speed. Thanks for help guys
Moderator
Joined: Feb 2000
Posts: 7,015
Likes: 2
From: Schererville , IN
Car: 91 GTA, 91 Formula, 89 TTA
Engine: all 225+ RWHP
Transmission: all OD
Axle/Gears: Always the good ones
Re: Does Hot Cam require ECM Changes
Start reading on the prom board and get ready to dig in.
U should have learned to tune on the stock setup first before doing mods, it would have made your life alot easier.
U should have learned to tune on the stock setup first before doing mods, it would have made your life alot easier.
Thread
Thread Starter
Forum
Replies
Last Post
junkcltr
Tech / General Engine
6
Aug 2, 2019 11:12 PM
