Knock sensor torque??
Thread Starter
Member
Joined: Jan 2001
Posts: 436
Likes: 0
From: Ft. Worth, TX
Car: 89 Turbo Trans Am and lots of non-3rd gens
Engine: 231 SFI Turbo's, LT4, LT1
Transmission: 2004r, 4L60E
Knock sensor torque??
What should the torque be on the knock sensor of a '92 5.7 TPI?
What will it do if to tight or not tight enough?
Thanks
------------------
Rob
High Performance & Party page
Pics of my rides past & present and recent party pics!
89 TTA #426 20th Anniversary turbo 3.8 bone stock
94 Silverado Tuned Port Injected
87 Grand National- lil' ole V6, highly modded
95 Trans Am Conv.- LT1
[This message has been edited by 2QUIK6 (edited March 11, 2001).]
What will it do if to tight or not tight enough?
Thanks
------------------
Rob
High Performance & Party page
Pics of my rides past & present and recent party pics!
89 TTA #426 20th Anniversary turbo 3.8 bone stock
94 Silverado Tuned Port Injected
87 Grand National- lil' ole V6, highly modded
95 Trans Am Conv.- LT1
[This message has been edited by 2QUIK6 (edited March 11, 2001).]
Supreme Member
Joined: Jul 1999
Posts: 5,183
Likes: 42
From: Oakdale, Ca
Car: 89 IrocZ
Engine: L98-ish
Transmission: 700R4
Too tight may damage it, not tight enough could let it leak coolant, not sure how the sensitivity would change though.
That said, I think spec is 15-18ft/lbs, basically tight as you can by hand, then maybe 1/2-3/4 turn more with a wrench.
I don't think you'll be able to get a torque wrench in there anyways.
That said, I think spec is 15-18ft/lbs, basically tight as you can by hand, then maybe 1/2-3/4 turn more with a wrench.
I don't think you'll be able to get a torque wrench in there anyways.
Thread
Thread Starter
Forum
Replies
Last Post
Ragtop Man
Transmissions and Drivetrain
2
Sep 12, 2015 12:23 AM
FormulasOnly
Tech / General Engine
3
Sep 10, 2015 09:07 PM
