Alright fellows I just did an engine swap, not to long ago and I m in the process of tunning it. Well anyway I got the codes 42,43 it only comes up when I get on it. But it only started after I adjusted my TPS, My TPS is bumped up .72 volts though I was going for .70 and had it there but when tighting I guess I bumped it. Well anyway cause I went over the max, would that be causing the prob? Thanks guys.

 

I think code 42 and 43 is an electronic egnition code usaly the problem is from the little brown wire that runs to your distibuter that you undo to time the engine check it and see if it has a good conection and it will probably go away.