Wiring harness removal help needed
Thread Starter
Member
Joined: Nov 2001
Posts: 229
Likes: 0
From: Jersey City, NJ
Wiring harness removal help needed
ok, I have everything else unbuttoned in the engine bay...except where the harness bulkhead plugs into the driver side firewall...what is the easiest way to get this accomplishd? I have tried to lift the clips on each side and pull the "plug" after taking the nuts off each of the bolts coming through the firewall...what's next or what should I do differently? Thanks for the help.
Junior Member
Joined: Aug 2001
Posts: 79
Likes: 0
From: Fredericksburg, VA
There is a bolt in the CENTER of the wires. accessible only from the interior. Its a pain in the *** to separate all the wires, but get it, and it shoul come apart
Mike
------------------
I would love to be there when those Muslim Bastards hit the Pearly Gates and realize they were wrong...
Mike
------------------
I would love to be there when those Muslim Bastards hit the Pearly Gates and realize they were wrong...
Joined: Dec 2000
Posts: 2,341
Likes: 151
From: Cincinnati,Ohio
Car: 1991 BandittII Firebird
Engine: 5.7 HSR
Transmission: 700R4
Axle/Gears: 3.27 9 bolt
on my 91 bird that center bolt was on the engine bay side of the firewall.
------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
www.gcfba.com (Greater Cincinnati F-Body Association)
http://www.cincyspeed.com/
------------------
1991 banditt2 #130 of 600
Project 350 TPI Banditt II
http://www.street-dawg-racing.cityslide.com
www.gcfba.com (Greater Cincinnati F-Body Association)
http://www.cincyspeed.com/
Thread
Thread Starter
Forum
Replies
Last Post