TPI plate setup....
Thread Starter
Member
iTrader: (3)
Joined: May 2006
Posts: 156
Likes: 0
From: Upstate, SC
Car: 87 Iroc Z
Engine: 305 TPI
Transmission: 700R4
TPI plate setup....
Just purchase a used Holley nitrous plate for $50. I was really wanting a nitrous outlet plate but $285 just sounds a little steep to me. Got a few questions:
Does anyone have this plate, and does it hit a lot harder than just a single nozzle?
Any gains going from nozzle to plate?
Is there anything more than just putting on the plate and spacing the throttle bracket forward, then setting the TV cable?
Does anyone else other than holley sell the plate to space forward the throttle bracket? Its $25 from Jegs. Ill probably just make one.
Does anyone have this plate, and does it hit a lot harder than just a single nozzle?
Any gains going from nozzle to plate?
Is there anything more than just putting on the plate and spacing the throttle bracket forward, then setting the TV cable?
Does anyone else other than holley sell the plate to space forward the throttle bracket? Its $25 from Jegs. Ill probably just make one.
Member
Joined: Oct 2005
Posts: 266
Likes: 0
From: califorina
Car: 1989 i roc-z28
Engine: 350 tpi l98
Transmission: 700r4
Re: TPI plate setup....
actually me and another Iroc in my town actuality gain .2 of a sec just using a single fogger with the same pills. the whole thing about it acting like a tb spacer might actually hurt performance like some people claim with the tb spacer. if you already got the plate use it because it makes for a cleaner install.
Thread Starter
Member
iTrader: (3)
Joined: May 2006
Posts: 156
Likes: 0
From: Upstate, SC
Car: 87 Iroc Z
Engine: 305 TPI
Transmission: 700R4
Re: TPI plate setup....
What is the problem with a TB spacer?
I also have a single NOS nozzle on the car now. I'll probably just run it with the nozzle and then change out for the plate and see what gains or losses I get. My single nozzle setup is clean also, I just bought it for performance.
I also have a single NOS nozzle on the car now. I'll probably just run it with the nozzle and then change out for the plate and see what gains or losses I get. My single nozzle setup is clean also, I just bought it for performance.
Thread
Thread Starter
Forum
Replies
Last Post
mhatfield 14
Tech / General Engine
5
Oct 24, 2015 07:48 AM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 12, 2015 03:41 PM





