Ac Delco 4-Wire Heated o2 Sensor
08-31-2009, 12:05 AM
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Feb 2007
Location: Tucson, Az
Posts: 659
Likes: 0
Received 0 Likes
on
0 Posts
Car: Don't
Engine: have
Transmission: it
Axle/Gears: anymore
Ac Delco 4-Wire Heated o2 Sensor
Whats up? I already have a 4-wire heated Denso o2 sensor installed on my GTA but due to a p.o.s. engine harness I have to replace it again 
. This time I'm not going to splice or cut into anything and I'm going to go 92GTA's route so it can look like it came like that from the factory. I found this Ac Delco unit: http://www.amazon.com/ACDelco-AFS98-.../dp/B000C9MHRI, which fits 98-02 Trans Ams. Anyone use this sensor before? As long as I use the proper pigtail, I shouldn't have any problems with it right? Thanks in advance.
Later,
Phoenix
. This time I'm not going to splice or cut into anything and I'm going to go 92GTA's route so it can look like it came like that from the factory. I found this Ac Delco unit: http://www.amazon.com/ACDelco-AFS98-.../dp/B000C9MHRI, which fits 98-02 Trans Ams. Anyone use this sensor before? As long as I use the proper pigtail, I shouldn't have any problems with it right? Thanks in advance.Later,
Phoenix
Thread
Thread Starter
Forum
Replies
Last Post
