thinking about getting slp runners and cutting them open need help
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: Southern IL
Posts: 1,942
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA "Cocaine"
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27
thinking about getting slp runners and cutting them open need help
yes I have done a search and have not come up with the info that I need.
what I would like to do is cut open the slp runners and port them all the way to the bottom. does anyone have a sort of pattern or diagram of where to cut and how do you cut the middle of the runner where the two tubes have the divider wall
thanks
what I would like to do is cut open the slp runners and port them all the way to the bottom. does anyone have a sort of pattern or diagram of where to cut and how do you cut the middle of the runner where the two tubes have the divider wall
thanks
#2
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,732
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: thinking about getting slp runners and cutting them open need help
#3
Supreme Member
iTrader: (7)
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,674
Likes: 0
Received 106 Likes
on
65 Posts
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Re: thinking about getting slp runners and cutting them open need help
#4
Supreme Member
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: Southern IL
Posts: 1,942
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA "Cocaine"
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27
Re: thinking about getting slp runners and cutting them open need help
yeah I have definatly seen that pic but I want to know how they cut the center of the runner.
#6
Supreme Member
iTrader: (8)
Join Date: Oct 2001
Location: Il
Posts: 11,723
Received 771 Likes
on
520 Posts
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: thinking about getting slp runners and cutting them open need help
Here are some ideas.
And if you want it to take forever and cost a bunch.
And if you want it to take forever and cost a bunch.
Thread
Thread Starter
Forum
Replies
Last Post
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM