O-ring size for the fitting on fuel rail?
Thread Starter
Senior Member
Joined: Dec 2007
Posts: 514
Likes: 62
From: Michigan
O-ring size for the fitting on fuel rail?
Ok so long story short I need a new o-ring for the fitting for my cold start FITTING that goes into the fuel rail. Despite plenty of lube the old one cut while reinstalling it.
Not the small one for the line out or the big one for the intake manifold, one for the fitting to the fuel rail that no o-ring kits have.
Anyone know a part number or o-ring size?
Not the small one for the line out or the big one for the intake manifold, one for the fitting to the fuel rail that no o-ring kits have.
Anyone know a part number or o-ring size?
Supreme Member
Joined: Jan 2000
Posts: 3,178
Likes: 48
From: Tracy, CA
Car: '87 IROC
Engine: LB9
Transmission: TH700R4
Re: O-ring size for the fitting on fuel rail?
Someone posted that it's a -113 but there's no follow-up confirmation if this was the correct size. See the last post in this thread:
https://www.thirdgen.org/forums/tech...ml#post5935387
https://www.thirdgen.org/forums/tech...ml#post5935387
Thread Starter
Senior Member
Joined: Dec 2007
Posts: 514
Likes: 62
From: Michigan
Re: O-ring size for the fitting on fuel rail?
Someone posted that it's a -113 but there's no follow-up confirmation if this was the correct size. See the last post in this thread:
https://www.thirdgen.org/forums/tech...ml#post5935387
https://www.thirdgen.org/forums/tech...ml#post5935387
Thx read that one and don't like to use unconfirmed info, I have enough trouble with stuff people say works LOL
Thread
Thread Starter
Forum
Replies
Last Post
knight72
Engine/Drivetrain/Suspension Wanted
0
Aug 10, 2015 09:32 PM