Hi Guys,

Just wondering if there's a trick or missing part needed to install the MAP sensor into the HSR upper plenum?

I have a MAP sensor off an LS1 to go with the 0411PCM, and it has the orange rubber barb seal on it, but there's no way I can press it into the 1/8-27NPT threaded hole in the HSR.

How does everyone else install theirs?
I thought I can probably cut the orange seal off, and use RTV sealant or something to hold it in place and seal, but will that be good enough, or is there a better way?

The other option I thought of it to have the MAP sensor mounted and pipe it to the intake, but would that cause issues with pressure delay or something having it remotely located?

 

Barb on intake, 4-6" of 1/4" or so rubber vacuum line run to the sensor mounted on firewall wiper lip lol

 

Awesome, thanks for that

 

Yeah just remote mount the sensor and remove the rubber seal. Works fine like that and wont leak