Stock fuel pump...
Thread Starter
Senior Member
Joined: Jun 2000
Posts: 781
Likes: 0
From: Palm Bay, FL
Car: 2007 Corvette Z06
Engine: LS7
Transmission: 6 speed
Stock fuel pump...
How much hp can the stock fuel pump support? I have a 89 305 TPI with 101,000 miles. A little worried about running out of fuel with a 100 shot of N20 or even the 60 shot i run now. My new mph should be around the 100mph mark after a cam swap and few other mods. So I figure ~275hp on motor plus 100 shot = fuel for 375+ hp? Also I bumped my fuel pressure up to ~51 psi. BLMs I saw were around 145-149 if that helps any.
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 2,361
Likes: 1
From: Savannah, GA
Car: 1997 Jeep Wrangler
Engine: 4.0L
Transmission: 5 speed
Axle/Gears: 8.8 rear, 4.56 gears, 4:1 transfer
Here's a chart to help you figure how much fuel pump you need. I do not know the GPH of a stock pump though.
http://www.lt1intake.com/engine_nitrous.htm
http://www.lt1intake.com/engine_nitrous.htm
Thread Starter
Senior Member
Joined: Jun 2000
Posts: 781
Likes: 0
From: Palm Bay, FL
Car: 2007 Corvette Z06
Engine: LS7
Transmission: 6 speed
well, assuming 155 l/hr??(i think that's the smallest fuel pump ratings) gives me like 425hp. I guess I'll try it and check the plugs every now and then.
By any chance did you get a new time with your tranny fixed yet?
By any chance did you get a new time with your tranny fixed yet?
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 2,361
Likes: 1
From: Savannah, GA
Car: 1997 Jeep Wrangler
Engine: 4.0L
Transmission: 5 speed
Axle/Gears: 8.8 rear, 4.56 gears, 4:1 transfer
Yes, tranny is fixed. Fuel pump is shot now (inline). When the pump gets hot is shuts down.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 25, 2015 11:49 PM





