trans cooler question
Thread Starter
Member
Joined: Jun 2002
Posts: 416
Likes: 0
From: Ocean State, lil Rhody, the biggest littlest state in the union, Rhode Island
Car: 1988 GTA Black/Gray
Engine: Blown 355
Transmission: 700R4
trans cooler question
Does anyone know which line at radiator is the feed and which is the return? 88GTA, 700R4.
Supreme Member
Joined: Nov 1999
Posts: 1,507
Likes: 0
From: Elizabeth, Colorado
Car: '94 Corvette
Engine: LT1
Transmission: 4L60E
No believing about it. The bottom is feed, and top is return @ the rad.
As far as the trannie to rad it's bottom to bottom, and top to top.
I researched the crap out it, a few years ago. You know back before the board was around. Ohhh the good old days, when Netscape could fit on a floppy, and web pages loaded in 1 second.
Ron
As far as the trannie to rad it's bottom to bottom, and top to top.
I researched the crap out it, a few years ago. You know back before the board was around. Ohhh the good old days, when Netscape could fit on a floppy, and web pages loaded in 1 second.
Ron
Thread Starter
Member
Joined: Jun 2002
Posts: 416
Likes: 0
From: Ocean State, lil Rhody, the biggest littlest state in the union, Rhode Island
Car: 1988 GTA Black/Gray
Engine: Blown 355
Transmission: 700R4
Thank you guys. This message board and its experienced members is definately the biggest helping hand I've found yet. Thanks again.
Hank O.
Hank O.
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
huh... same question i had. I just assumed it was reverse flow cooling in the radiator and hooked it up to the top one. Thanx
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM
84z96L31vortec
North East Region
1
Aug 10, 2015 08:27 PM