9in in third gen how hard
Thread Starter
Junior Member
Joined: Jul 2002
Posts: 37
Likes: 0
From: edison,nj
9in in third gen how hard
i can get a 9in thats really nice all i need is the pumpkin but how hard is it to put in a 87 iroc. the 9in came ou tof a 57 fairlane but was completely rebuit for a project mustang but was to short
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
all you need to do to make it work is relocate the brackets off your facotry rear and fab up a little bracket for the torque arm, or make or buy a 4 link or ladder bar set up. it'll bolt right up. makesure the width is correct of change the width to something you can use.
TGO Supporter
Joined: Nov 2001
Posts: 11,634
Likes: 3
From: Maryland; USA
Moderator
Joined: Jul 1999
Posts: 17,271
Likes: 171
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
The 57 Fairlane diff will be too short for a third gen also. Should be about 3" shorter on each side.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
AkDrifted
Engine/Drivetrain/Suspension Parts for Sale
6
Aug 17, 2015 07:45 PM
