Replacing TO bearing
Thread Starter
Junior Member
Joined: Sep 2002
Posts: 61
Likes: 0
From: North Jersey
Car: 87 Camaro Vert
Engine: Cammed LT1
Transmission: T-5
Replacing TO bearing
So my throwout bearing is gone, and I have question. Do I need to drain the trans fluid. I don't see why I would but I read somewhere that you need to. I'm also going to have to align the clutch up again correct? I haven't done much clutch work before, so any help would be appreciated.
Senior Member
Joined: Dec 1999
Posts: 770
Likes: 0
From: San Antonio, TX
Car: 86Z/92 RS Camaro
Engine: 357 vortec finished. need tuning
Transmission: Still works
Axle/Gears: need 3.73
No to both questions. Unless you plan to remove the clutch then you will need to align them up again.
Thread
Thread Starter
Forum
Replies
Last Post
red90IROCls1
Transmissions and Drivetrain
10
Aug 25, 2015 06:56 AM
Thirdgen89GTA
NW Indiana and South Chicago Suburb
0
Aug 20, 2015 03:11 PM
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM