Ground clearance problems with a TKO?
Thread Starter
Supreme Member
iTrader: (2)
Joined: Jan 2002
Posts: 9,962
Likes: 5
From: Moorestown, NJ
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
Ground clearance problems with a TKO?
Ive heard that ground clearance can be an issue with the TKOs because they hang down a bit. How bad is it?
Supreme Member
Joined: Sep 2001
Posts: 1,266
Likes: 4
From: Tallahassee, FL. USA
Car: 92 Camaro RS
Engine: 350 Crate Motor
Transmission: Tremec TKO
Axle/Gears: 10 Bolt 3.73
There's just one part of the casting of the case that hangs lower than the crossmember. Crossmember is spaced down from the frame 3/4" to fit it in there.Drags on speed bumps if I take them too fast. My car is lowered over 1-1/2".
The trans is pretty tall compared to the T5. Also since it's mounted vertically instead of at the angle the T5 mounts at, makes it a pretty tight fit.
It hasn't really been much of a problem, though.
-Rich-
The trans is pretty tall compared to the T5. Also since it's mounted vertically instead of at the angle the T5 mounts at, makes it a pretty tight fit.
It hasn't really been much of a problem, though.
-Rich-
Thread
Thread Starter
Forum
Replies
Last Post
