transpack
#1
Junior Member
Thread Starter
Join Date: Oct 2005
Location: loretto ky
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 gta
Engine: 350 tuned port
Transmission: 700r4
transpack
Can anyone tell me if theyre worth installing in my ride I'm looking to get rid of that slow shifts I just finished insatlling a set of hedman shorties, a y-pipe that I made flowmaster exhaust. ported upper plennum. msd coil, tps airfoil, k&n air filter with cold air box. I'm dying to hear it run and also a jet stage 2 chip do you think it'll help
#4
Moderator
Join Date: Feb 2000
Location: Schererville , IN
Posts: 7,015
Likes: 0
Received 1 Like
on
1 Post
Car: 91 GTA, 91 Formula, 89 TTA
Engine: all 225+ RWHP
Transmission: all OD
Axle/Gears: Always the good ones
By Transpak I take it your talking about the B&M shift kit correct?
It will make the shifts harder, its about all their shift kits do.
I would personally go with the TransGO shift kit instead. They actually engineer their kits to fix factory issue sin the trans and to shift firm under part throttle and hard under WOT. Much better overall solution.
Also note on anything Hypertech concerning our cars, ask anyone who has compared them side by side to factory proms. You are doing nothing other than wasting your money. Learn to do your own proms or become friends with someone who can
later
Jeremy
It will make the shifts harder, its about all their shift kits do.
I would personally go with the TransGO shift kit instead. They actually engineer their kits to fix factory issue sin the trans and to shift firm under part throttle and hard under WOT. Much better overall solution.
Also note on anything Hypertech concerning our cars, ask anyone who has compared them side by side to factory proms. You are doing nothing other than wasting your money. Learn to do your own proms or become friends with someone who can
later
Jeremy
#5
Junior Member
Thread Starter
Join Date: Oct 2005
Location: loretto ky
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 gta
Engine: 350 tuned port
Transmission: 700r4
Thanks for the info I'll take the jet chip back then it hasen't been opened yet so it shouldn't be any problem anything else recommended would also be greatly appreciated. I'm on a tight budget so every little bit helps. I'm not trying to make a race car but I do want to turn heads of those Mustang geeks who think they have something
#6
Moderator
Join Date: Feb 2000
Location: Schererville , IN
Posts: 7,015
Likes: 0
Received 1 Like
on
1 Post
Car: 91 GTA, 91 Formula, 89 TTA
Engine: all 225+ RWHP
Transmission: all OD
Axle/Gears: Always the good ones
Well for playing with the trans, I would get a Trans Go kit hands down.
Maybe a nice converter to go with it if u can swing it.
U will be lots better off asking questions and searching here for answers than u will be by buying whatever magazine hype u see :-)
Lots of smart folks here.
Prom burrning board is a great resource here also, just expect to read a whole lot for it all starts clicking.
Search for "free mods" and the like and you should net lots of cheap/free ideas that will work on TPI cars
later
Jeremy
Maybe a nice converter to go with it if u can swing it.
U will be lots better off asking questions and searching here for answers than u will be by buying whatever magazine hype u see :-)
Lots of smart folks here.
Prom burrning board is a great resource here also, just expect to read a whole lot for it all starts clicking.
Search for "free mods" and the like and you should net lots of cheap/free ideas that will work on TPI cars
later
Jeremy
#7
Junior Member
Thread Starter
Join Date: Oct 2005
Location: loretto ky
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 gta
Engine: 350 tuned port
Transmission: 700r4
sounds like the trans-go kit is the way to go. thanks again, the prom burning sound all well and good, but I've read a few posts on it and I didn't understand any of it would it be better to find a reliable source to burn mine?
Trending Topics
#8
Supreme Member
iTrader: (1)
Join Date: Jul 2005
Location: Rockville, Maryland
Posts: 2,435
Likes: 0
Received 1 Like
on
1 Post
Car: 1986 Z28 Camaro Gunmetal Gray with
Engine: GM Crate ZZZ HO 350, Edelbrock head
Transmission: Rebuilt 700r4 all TransGo and Beast
Axle/Gears: 10 bolt with 3.73 gears
you wanna buy a transgo kit? i f'ed up and bought one and decided not to use it and the place wont take it back.
and i think the transpak is different from the shift improver kit by the way. not sure how though.
and i think the transpak is different from the shift improver kit by the way. not sure how though.
Thread
Thread Starter
Forum
Replies
Last Post
C409
Engine/Drivetrain/Suspension Parts for Sale
2
01-22-2013 09:56 AM
TADailyDriver
Tech / General Engine
3
07-20-2008 01:34 PM
91L98
Transmissions and Drivetrain
2
04-06-2001 05:31 PM