B&M Transpack question.
Thread Starter
Junior Member
Joined: Jul 2013
Posts: 19
Likes: 0
From: Philadelphia
Car: '87 Trans Am GTA
Engine: 5.7L 350cu.
Transmission: 700r4
Axle/Gears: Stock
B&M Transpack question.
Hey, I was looking over the instructions for the transpack and it seems that only one or two replacement part are in there that make any difference. The other mods are removing springs/check ***** and drilling holes in the plate... Is there a problem with just doing the drilling and removing mods without buying the kit?
Here's the instruction manual:
http://bmracing.com/wp-bnmcont/uploads/70235.pdf
Thanks guys.
Here's the instruction manual:
http://bmracing.com/wp-bnmcont/uploads/70235.pdf
Thanks guys.
Joined: Oct 2001
Posts: 12,213
Likes: 1,140
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Moderator
Joined: Aug 2004
Posts: 1,367
Likes: 0
From: Nanticoke, Pa
Car: 89 Firebird
Engine: 406 CI
Transmission: Pete K 700R4
Axle/Gears: 3:55
Re: B&M Transpack question.
Hey, I was looking over the instructions for the transpack and it seems that only one or two replacement part are in there that make any difference. The other mods are removing springs/check ***** and drilling holes in the plate... Is there a problem with just doing the drilling and removing mods without buying the kit?
Here's the instruction manual:
http://bmracing.com/wp-bnmcont/uploads/70235.pdf
Thanks guys.
Here's the instruction manual:
http://bmracing.com/wp-bnmcont/uploads/70235.pdf
Thanks guys.
Thread
Thread Starter
Forum
Replies
Last Post
ZZ3Astro
Power Adders
1045
Aug 13, 2019 12:57 AM