ok i have the tranny back in the car, now im in a pickle, driveshaft wont go in all the way to clear the yoke, now what do i do

 

where do you have the rear of the car supported?

 

it came out where i have it supported, rubber mounts on sway bar, if you look at the shiny part of the yoke that goes into the output shaft , half of it slides in and then it just stops, i took it back out and tried again and it just slides in and just stops, seems like it is hitting something

 

Try rotating it a little when you pull it out, then put it back in.

 

it was the new bushing i installed, i took the extension housing off and put the driveshaft in it and the new bushing was catching it.my old one most of been worn out pretty good, sanded the yoke down a little with emery cloth, had to turn and push it
in , its in now, thanks 87zjeff and BRobinson