B&M shifter
Joined: Aug 2006
Posts: 12,803
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
are you talking about the console megashifter?
i have seen it installed on a crapper car before, look, cool, but is a little higher that stock, didnt get to sit in the car and see if it feel weird at that height, been thinking about doing one my self, but the only pic that i have found of it dont show and od position
, and i dont want to loose od.
i have seen it installed on a crapper car before, look, cool, but is a little higher that stock, didnt get to sit in the car and see if it feel weird at that height, been thinking about doing one my self, but the only pic that i have found of it dont show and od position
, and i dont want to loose od. 
Junior Member
Joined: Jun 2006
Posts: 86
Likes: 1
From: Ft. Lauderdale, FL
Car: 91 Z28
Engine: 305 TPI
Transmission: TH700-R4
Axle/Gears: 3.73
i hated my stock shifter... nothing but a POS. it was abused by me and didn't hold up and i ended up breaking it. the shift indcator was always wrong. till i replaced the shifter cover. then a few months later it broke too. then finally i got the megashifter when the stock shifter poped out of park and rolled from the driveway into the street. at least with the megashifter it stays put. As for OD yes it does work with overdrive transmissions.
Thread
Thread Starter
Forum
Replies
Last Post
