drive shaft help
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 1
Likes: 0
From: ohio
Car: 1984 camaro
Engine: 350 w/ 367 hp
Transmission: th 350
drive shaft help
I have an 1984 camaro i am putting a 350 in it............. i was putting the engine and tranny in and i figured out that my drive shaft was too shot it is a 6 inch tailshaft..... does anyone know what size driveshaft i will need... and also i cant remember if my car had a tranny crossmember its been a while since i have tore it apart and i cant remember if it had one or not. i am new to this stuff so any answers would be appriciated...... thanks
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
A 
on this site is always a good idea, as I'm sure the subject has been covered before. Can't help on the drive shaft, but you should have a tranny cross member. Some cars even have a secondary cross member:
https://www.thirdgen.org/forums/hist...ss-member.html
Should you have this secondary member and require new GM isolators (the red donuts), I have a new set. Cost plus shipping.
JamesC
on this site is always a good idea, as I'm sure the subject has been covered before. Can't help on the drive shaft, but you should have a tranny cross member. Some cars even have a secondary cross member:https://www.thirdgen.org/forums/hist...ss-member.html
Should you have this secondary member and require new GM isolators (the red donuts), I have a new set. Cost plus shipping.
JamesC
Thread
Thread Starter
Forum
Replies
Last Post
1992rs/ss
Engine/Drivetrain/Suspension Parts for Sale
16
Jan 28, 2016 09:58 PM
Ozz1967
Transmissions and Drivetrain
4
Aug 16, 2015 10:23 PM